Communicator voice messages for alarms

Functions as an accessory to a master computer (control panel, or robots in general, any computer or TTL output 0/12V), as well as autonomously as a small robot with sensors connected to the inputs of their areas .
● Three trigger inputs, immediate or delayed (zones 1-3) and an instant panic input 24 hours (zone 4), all enabled or disabled with access code.
Various possibilities of configuring zones, in programming mode you can set the trigger type of each zone, delayed or instantaneous.
The zones were set up your positive or negative activation (12V or 0V), or TTL level trigger level 5V or 0V. For standalone operation mode, the zones can also be configured as end of line. In this case the bonds should be connected by means of resistance of 2.2 Ohm.
4 voice messages of up to 10 seconds, each of these messages can be transmitted to 6 phone numbers (these can be formed by a maximum of 15 digits, with the option to insert a 2 second pause when dialing). Each message can be transmitted by the 4 alarm events, and transmit the message to the phone numbers (numbers that are marked in the case of an alarm on any of the areas) and two "individual", exclusively assigned to each area. As such, a maximum of 12 phone numbers can be programmed
The storage of the programming is done in a nonvolatile memory EEPROM, phone numbers, equipment parameters and the 4 voice messages, the setting will be stored even if the computer loses power.
● It also keeps a small non-volatile memory for events, stores (unarmed / armed / alarm and the areas that are active in this state of alarm) in case of power failure and restore the memory stores the previous state and the sample to recover Food
Optoelectronic circuits for interfacing with the telephone line, which includes surge protection.
Programming ● dial tone detection
● A report output (REP, configurable to 12V or 0V) that can be programmed to inform the control panel of a power failure or telephone line to report an alarm event.
● An open collector output (max. 1A), which allows the connection of a siren (or other units).
● panic function, which immediately activates the call cycle and emergency siren, activated by the keyboard or input zone 4



REFERENCE
4 zone inputs
Output 2
Number of Posts 4
12 programmable phones
Power 10V DC - 15V DC
Consumption 30 mA ~ 60 mA